No need to connect Car Inverter, battery as power supply, easy to carry. Support household electricity and cigarette lighter to recharge or use as power supply. Support recharging and working at same time, with high-capacity up to 76.5Wh, cutting more than 40 key blanks. Maximum working voltage no more than 30V, built-in muti-safty protection, to avoid short in circuit problems.
How to Upgrade Condor XC-MINI Built-in Power Supply?
1.Remove the screws.
2.Remove the shell.
3.Rotate the little round screw to the innermost.
4.Then we need to remove the clip.Pull it out.
5.Rotate the screws on both sides,remove out the clip.
6.Use insulating tape to connect two cables together.
7.Lay down condor mini machine.Remove the screw.
8.Take out the board.Unplug the clip.
Rotate two screws to remove the PCB.
9.Here two separate yellow color cable,number 7 and 6.
10.Number 6 cable connects 12 on clip.
Cable 7 connects with 11.Lock the screws.
11.Put back clip to original place.
12.Next step: remove the power adapter on Condor MINI
13.Put the new power adapter.You can find new power adapter in Power Supply Adapter with Battery Kit.
Put back screws and lock it.
14.Put two yellow cables together with new power adapter cables under the clip through the hole.
15.Connect Power Adapter battery PCB.
It lists out number from 1 to 9,and 24V.
16.Connect cables to the numbers, VCC and GND. Please note the numbers must be matched.
Connect cables,as well as VCC and GND.
17.Put back PCB to condor mini.And two shells,lock the screws.
18.Now,we power on to start for test.It shows charge capacity.
19.Use old charge cable with new charge adapter,connect with power supply,it can charge power.
We can also use Car cigarette lighter cable to charge.
20.Upgrade to the built-in power supply successfully.
21.You can also check our operate video.
[embed]https://www.youtube.com/watch?v=1_I-Ywb2gqM[/embed]original:How to Upgrade Condor XC-MINI Built-in Power Supply?
没有评论:
发表评论